Spectrum-controls 140 MPM 204 00sc Manual de usuario descargar pdf (Pagina 10)

Quantum Series 140 MPM 204 00sc

HardwarHardwar

Hardwar

DescriptionDescription

Description

Door (removable) Covers the terminal block and includes an identification label for terminals.

Door label Permits easy terminal identification.

LED indicators Display operating and fault status of module.

Details are provided in “

Diagnostic LEDsDiagnostic LEDs

Diagnostic LEDs”.

Side label (nameplate) Provides module identification.

Self-locking tabs Secure module in rack slot.

Terminal block Used for field wiring the module.

Diagnostic LEDsDiagnostic LEDs

Diagnostic LEDs

The module supports the LEDs listed in table 1-1 . These LEDs help you identify the source of problems that

can occur during power-up or during normal operation. Power-up and operation diagnostics are explained in

chapter 5, “Maintenance and Diagnostics.”

able 1-1 Module LEDsable 1-1 Module LEDs

able 1-1 Module LEDs

LED NameLED Name

LED Name

ColorColor

Color

StateState

State

State DescriptionState Description

State Description

Ready (Module Status) Green On Module powered up and functioning normally.

Off Module is not powered up.

Active Green On Bus communication is established between module and PLC.

Off No bus communication.

Fault Red On Module self-test error or fatal hardware error. LED blinks to

indicate type of self-test error.

Blinking Type of self-test error. Count the number of blinks before a

pause to determine the error code. Possible codes are listed in

the table below.

Channel Status (8 LEDs) Green On Channel is enabled and a valid input signal is present. The

LED indicates the state of the counter enable bit. It does not

indicate the state of an external hardware gate. See description

of the counter enable bit in chapter 3, “Module Configuration.”

able 1-2 Channel LED Blink Codesable 1-2 Channel LED Blink Codes

able 1-2 Channel LED Blink Codes

Code (Number Code (Number

Code (Number

of Blinks)of Blinks)

of Blinks)

ErrErr

Err

oror

ypeype

ype

On Solid No Faults

1 Frequency Limit Out of Range.

2 Not applicable

3 Not applicable

4 Channel Pair Gate Enable Configuration Mismatch.

5 Quadrature Pair Configuration Mismatch.

6 Not applicable

7 Not applicable

8 Unrecognized parameter type.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 65 66

Comentarios a estos manuales

Sin comentarios

Spectrum-controls 140 MPM 204 00sc Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Spectrum-controls 140 MPM 204 00sc